![]() (6000 km is one side of the equilateral triangle of satellites.)į) Perform the maneuver, then circularize at apokee.ģ) For the third satellite, do it just like the second, but referenced to the second satellite instead of the first. RemoteTech allows you to construct vast relay networks of. Rotate it west-ward until the closest point of approach to the target is about 6000 km. A community-developed continuation of the original RemoteTech mod for Kerbal Space Program. Set up a maneuvering node at approximately 60 degrees east around your orbit from KSC.Ĭ) Add prograde to the maneuvering node until the apogee is at geosync height (2868.75 km)Į) Now grab the maneuvering node ring so you can rotate it around your orbit. (Don't worry if you lose comms you'll get them back in time for your maneuver.) Here's how to get it there.Ī) Put your second vessel in 100km circular Kerbin orbit. However, I am aware KerbNet is a feature implemented by Squad, but up until this day, I dont understand a single bit of it, where Im currently reinstalling for KSP 1. Push your apoapsis out to near geo-sync height (2868.75km) then cut your engines, coast there, and burn to circularize.Ģ) The second satellite should be 120 degrees retrograde from the first satellite. Hey all, In these last years I have always played KSP using the mod RemoteTECH (and SCANsat) and got very accustomed to them and their challenging, realistic mechanics. ![]() Don't forget to turn on LoS requirement and antenna required for probe control options itsamee 9 yr. Doesnt have to be high, but at least over 500m. slightly less complicated, but still the basic principle. The other cheaper option is to right-click your parachutes and set the altitudes to deploy. It is the non-relay version of the RA-2 Relay Antenna. It is a medium sized antenna, more powerful than the Communotron 16, and weaker than the Communotron HG-55. It is deployable, and must be deployed before use. To do this, just make your ascent very steep do only a very slight gravity turn. 1 Answer Sorted by: 1 One option is to have a lower-orbit set of satellites at 300kms so you can use the DP-10. The Communotron DTS-M1 is an antenna, used to connect to CommNet and transmit science. I do not remeber the specifics, but OP claimed 99.99 reliability with just a single stationary Kerbin orbit probe to manage. The logic was that relays would move slowly at apoapsis and quite fast at periapsis. My problem is this: how on earth to do it?ġ) The first satellite should go as close to as possible directly above KSC, and you need to get it there before you orbit, or you'll lose communication. There was a post recently about using elliptical orbits in conjunction with RemoteTech.
0 Comments
Leave a Reply. |